Steel Commando Roadster Gas Tank for 750 and 850s
Part Number 06-2701/092
Superseded number: 06-2026
Steel Commando Roadster gas tanks for 750 and 850s Necks are now
sourced in the UK for proper fit.
UNPAINTED STEEL, BARE
Height of tank max 8” approx.
Length of tank 21” approx.
9-1/2” max width at bottom
Tunnel length 18"
Tunnel width narrowest 3-1/2"
Tunnel width at front 4-1/4"
Tunnel depth at front 6-1/2"
use with:
Gas Taps:
1) #621-131
1) #621-132
2) #70-7351 - Bonded washer
2) #83-0002 - Steel washer
Decals:
2) #06-4880 - Gold decal >> alternate #06-4881 black or #06-4882 silver
1) #00-9195 - Reserve decal
Mounting Hardware:
2) #06-3215 - Front stud
2) #06-0797 - Front stud nut >> alternate #14-1302
2) #01-4999 - Front stud washer
8) #06-0648 - Front stud rubber washer
1) #06-3121 - Mounting strap
2) #06-0359 - Mounting strap bolt >> alternate #14-0113
2) #00-0011 - Mounting strap washer >> alternate #60-2321
1) #06-0681 - Gas cap
It is highly recommended that all fuel tanks be fitted, pressure tested, and sealed before painting.
We recommend #235-02 Gas Tank Sealer. This sealer is a two-part
epoxy, with no solvents, and is ground shippable by mail and UPS.
WARNING: When installing these fuel tanks ALL frame, motor, carburetor, cable and
bracket clearances must be checked with the fuel tank full to insure there are sufficient clearances
when the motor is cold and hot. All hardware must be properly installed and tightened accordingly.
Please pressure test gas tanks prior to painting. All parts must be fitted prior to painting the
tank to be sure that no problems are encountered later.
Please note, although we only sell parts from reliable manufacturers, warranties are limited only to
replacement of defective parts, and no labour of any type, including paint jobs or return shipping,
is ever covered.